Cleaning and Inspection. - TM-9-2815-224-34-P0086

TM 9-2815-224-34&P

Cylinder Head Maintenance Instructions

3-7. CYLINDER HEAD REMOVAL/INSTALLATION (CONT).

NOTE

Compression gaskets are color coded. Be sure

to note color for replacement.

Remove seal strip gasket (32), two

(17)

support shims (33), seventeen water

seals (34), oil seal (35), and four

compression gaskets (36).

Remove gasket (37) from crossover

(18)

tube (13).

b. Cleaning and Inspection.

WARNING

Adhesives, solvents, and sealing compounds

can burn easily, can give off harmful vapors

and are harmful to skin and clothing. To

avoid injury or death, keep away from open

fire and use in well-ventilated area. If

adhesive, solvent, or sealing compound gets

on skin or clothing, wash immediately with

soap and water.

Clean cylinder head (1) with

(1)

drycleaning solvent.

WARNING

Compressed air used for cleaning purposes will not exceed 30 psi. Use only with

effective chip guarding and personal protective equipment (goggles/shield, gloves,

etc.)

Dry cylinder head (1) with compressed air.

(2)

Inspect cylinder head mounting surface to be sure it is clean and free from burrs.

(3)

Change 2