Assembly-continued - TM-9-2815-224-34-P0063

TM9-2815-224-34&P

Engine Block Maintenance Instructions (Cont)

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

NOTE

There are 14 plugs, seven in each cylinder bank. Apply small quantity of

sealing and lubricating compound to thread area above plug. Do not let sealant

get onto threads of cylinder head screws, allow sealant to set for 12 hours

before performing pressure check section d. Testing

Top of plugs must be 1.960-in. (50 mm) below surface of block when installed.

(32) Coat threads of 1 1/16-in. plugs (47) with sealing and lubricating compound and install in cylinder

head screw holes (48). Tighten to 50 to 60 lb-ft (68 to 81 Nm).

(33) Install two dowels [49) in front of engine

block (5) until they-stick out 3/8-in. (9.5 mm)

(34) Install three p] ugs (50) and two plugs (51 ).

TA357794

(35) Install two dowels (52) in rear of engine block (5) until they stick out 3/8-in. (9.5 mm).

(36) Install cup plug (53) in bottom of engine block (5).

3-15