 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TESTS AND ADJUSTMENTS (CONTINUED)
FUEL SOLENOID TEST
CAUTION
Current with solenoid energized (plunger up)
should be about 0.3 amps. If current is much
greater than 0.3 amps, turn fuel switch OFF im-
mediately. Replace defective solenoid.
D Place fuel switch in ON position.
E
Note current on ammeter.
,
F
Place fuel switch in OFF position.
FUEL SOLENOID ADJUSTMENT
NOTE
Solenoid plunger length is adjusted to
stop
fuel injection when solenoid is de-energized.
A Loosen nut (3).
B Back off adjustment screw (4) to fully stop fuel injection.
C Tighten nut (3).
NOTE
A Disconnect solenoid control wire (1) at solenoid terminal (2).
If plunger sticks, remove solenoid. Clean plunger
B Connect wire lead between positive terminal of low voltage
and plunger recess in solenoid.
tester
ammeter and
terminal (2).
C Connect control wire (1) to negative
terminal of
0985
TM 9-2815-221
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals