 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
AND RING GEAR REPAIR (CONTINUED)
INSTALLATION
A Place flywheel-to-crankshaft key (1) into crankshaft
VALVE STEM WIT
keyway.
VALVE SPRING AN
RETAINER REMOVE
B Install flywheel (2) on crankshaft (3).
c
Install flat washer (4),
(5), and screw
in
crankshaft (3).
D Torque screw (6) to 65-70
q
q
NOTE
Replacement flywheels are supplied without tim-
ing markings because each flywheel must be fit-
ted to its engine. The only accurate method of
determining top dead center
and port clos-
ing (PC) points is to measure piston travel.
Measurement should only be attempted with ac-
curate, dependable equipment.
E Turn flywheel clockwise until No. 1 cylinder is on
compression.
\
F
Remove No. 1 exhaust rocker arm, valve spring locks, valve
stem caps, valve spring retainer, and valve spring (p 3-38).
4
G Allow exhaust valve to drop down onto top of piston.
H Install dial indicator on top of No. 1 cylinder exhaust valve
stem.
For replacement of flywheel follow steps E-N.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals