 |
|||
|
|
|||
|
Page Title:
INSTALLATION OF ENGINE MOUNTING BRACKETS AND INSTALLATION OF ENGINE ON OVERHAUL STAND |
|
||
| ||||||||||
|
|
 in flywheel housing and secure with eight 1/2-
inch plain nuts and 1/2-inch lock washers.
B) Install engine front mounting brackets on
engine front plate and secure with four 7/16 x
- 3/8 cap screws and 7/16- inch plain nuts.
C) Install rope sling around cylinder and
crankcase assembly and lift engine f rom blocks.
b. Install Stripped Engine on Overhaul Stand.
install stripped engine on overhaul stand as
follows.
Note. Engine overhaul stand must be in-
verted and one side rail removed to install
engine.
INSIDE RIM FOR OUT-OF- ROUND.
BRACKETS AND INSTALLATION OF
ENGINE ON OVERHAUL STAND
a. Install Engine Mounting Brackets. Figure
ON CRADLE -7950198 OF ENGINE OVER-
HAUL STAND - 7950189.
(1) Figure 478. (A) Lift engine to overhaul
stand and side rail as shown. (B) Install
side rail by reversing the sequence of
instructions given in step A of fig-
ure 297.
(2) Refer to figure 296 and reverse the in-
structions in step B to secure the front
mounting brackets to side rails.
(3) Refer to figure 295 and reverse the in-
structions in step B to secure rear
mounting brackets to side rails.
(4) Remove rope sling.
304
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals