 |
|||
|
|
|||
|
Page Title:
Section II. REBUILD OF CLUTCH ASSEMBLY |
|
||
| ||||||||||
|
|
 levers. The release levers pivot on re-
246. DATA
lease lever pins moving the pressure
plate away from the driven member as-
Make . . . . . . . . . . . . . .. Long
sembly and against the pressure
Model . . . . . . . . . .
springs. Although the clutch cover as-
Type . . . . . . , . . . dry, single plate
sembly still rotates at flywheel speed,
Ordnance number . . . . . . . .7748995
the driven member assembly slows down
and stops. When the clutch pedal is re-
leased, the throwout bearing moves
away from the release levers and the
Three improvised tools are needed to rebuild
pressure springs force the pressure
the clutch assembly: clutch spacer plate (fig.
plate toward the flywheel. This engages
the driven member assembly and trans-
mits flywheel motion to the transmission
pins (fig. 36). The tools are listed in paragraph
input shaft.
45 and tabulated in Table II.
Section II. REBUILD OF CLUTCH ASSEMBLY
248. DISASSEMBLY
Note. The four spacer blocks were installed
before the clutch cover was removed from the
engine (fig. 274). The spacer blocks prevent
a. Remove Spacer Blocks. Figure 448. (A)
clutch cover distortion as the cover retaining
Position clutch cover assembly on a flat surface
screws are removed.
as shown. Push down on four release levers.
(B) Remove four clutch release lever spacer
b. Scribe Alinement Marks. Refer to figure
blocks.
sembly.
ON CLUTCH COVER AND PRESSURE
SPACER BLOCKS BETWEEN RELEASE
LEVERS AND CLUTCH COVER.
PLATE.
287
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals