 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (3) Figure 232. (A) Remove fuel injector
nozzle and holder assembly. (B) Remove
and discard fuel injector to head gasket.
(C) Remove the remaining five fuel in-
jector nozzle and holder assemblies and
gaskets in the same manner.
a. General. The oil filter elements are in-
stalled in the oil filter cases mounted at the
upper left center of the engine.
b. Removal. Remove the oil filter elements
as follows.
(1) Refer to figure 233 and disconnect oil
filter cases.
REAR OIL FILTER ELEMENTS.
AND OIL FILTER HOUSING AND
TAPPET CHAMBER COVER
a. General. The engine lubricating oil is
cooled as it passes through the oil cooler. The
oil cooler is mounted on the oil cooler and filter
housing assembly forward of the oil filter.
FILTER CASE AT OIL FILTER HOUSING.
b. Removal. Remove the oil cooler, oil
cooler and filter housing, and tappet chamber
cover as follows.
(2) Figure 234. (A) Remove rear oil filter
case and bar. (B) Remove and discard
(1) Figure 235. (A) Loosen two 2-inch id
rear oil filter element. (C) Remove and
hose clamps securing oil cooler water
discard oil filter case gasket. (D) Un-
inlet hose. Slide hose back on oil cooler
screw bar securing front oil filter case
water inlet tube. (B) Remove four 5/16-
to oil cooler and oil filter housing and
inch plain nuts and 5/16-inch lock
remove case, element, and gasket in the
washers securing oil cooler water inlet
same way.
tube to water pump body. (C) Disconnect
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals