 |
|||
|
|
|||
|
Page Title:
VALVE ROCKER ARM ADJUSTING SCREWS |
|
||
| ||||||||||
|
|
 (B) Remove six 3/8 x 2- 1/2 cap screws
head water outlet manifold. Use new
and 3/8- inch lock washers securing the
cylinder head water outlet manifold gas-
three rocker arm shaft supports to the
kets.
cylinder head.
Note. The rear cylinder head water
(3) Refer to figure 181 and remove front
outlet manifold is installed in the same
rocker arms.
manner.
(2) Refer to figure 62 and reverse the se-
quence of instructions to install the front
cylinder head cover. Use new gaskets
under cover and breather adapter.
a. General. When one or more valve rocker
arm adjusting screw-s need replacement, remove
the front and/or rear set of rocker arms. For
instructional purposes, the f rent set of rocker
arms will be removed.
b. Removal. Remove valve rocker arm
adjusting screws as follows.
(1) Remove front cylinder head cover and
FRONT ROCKER ARMS.
gasket following instructions for fig-
ure 62.
(4) Figure 182. (A) Remove valve rocker
adjusting screw lock nut. (B) Turn
(2) Figure 180. (A) Loosen six valve rocker
rocker arm adjusting screw clockwise
adjusting screw lock nuts and alter-
to remove it from rocker arm assembly.
nately loosen valve rocker adjusting
screws to relieve valve spring tension.
VALVE ROCKER ARM ADJUSTING
SCREW.
c. Installation. Refer to figures 180 through
CAP SCREWS SECURING ROCKER
182 and reverse the sequence of illustrations
ARM SHAFT SUPPORTS.
and instructions to install the valve rocker arm
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals