 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 case to head. Remove preformed pack-
ing from nut and discard packing and
flat washer. (D) When installing full
filters, torque case nut to 275 to 325
pound inches.
FUEL FILTER ELEMENT AND FUEL
FILTER CASE.
FILTERS - INSTALLED VIEW.
Note. The oil filter elements are the same
(2) Figure 104. (A) Remove fuel filter case.
and are replaced in the same manner. If either
(B) Remove fuel filter element. (C) Re-
oil filter element requires replacing, both must
move and discard fuel filter case gasket
be replaced. For instructional purposes, the
from filter head.
rear oil filter element is replaced. The filter
elements are available in a parts kit which in-
Note. Leave vent valve open until en-
cludes the element and gaskets. Refer to TM 9-
gine fuel system has been purged.
2815-204-35P for components of the kit. One of
the gaskets, part No. 8725201, included in this
universal kit is not applicable to this engine and
b. Installation.
must be discarded.
Note. Clean fuel filter case with dry- cleaning
a. Removal.
Remove oil filter elements as
solvent or mineral spirits paint thinner before
follows.
installing new element.
Refer to figures 103 and 104 and reverse the
(1) Figure 105. (A) Remove 3/8-inch pipe
sequence of illustrations and instructions to in-
plug from oil filter and oil cooler hous-
stall the new final fuel filter element and gasket.
ing and allow oil to drain into a suitable
The element must be properly located on pilot
container. (B) Unscrew bar securing
in filter head before installing case.
rear oil filter case to oil filter and oil
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals