Figure 6-213. Disassembling or assembling right camshaft cover plate.

Disassemble

5. Remove bushing-type bearing (E) only if inspection

(para. 6-44c) indicates the need for replacement. To

remove, press bearing from end plate.

Note. The left camshaft cover plate assembly

Assemble

and associated parts are similar to the right

1 . If bushing-type bearing (E) was removed, press

cam shaft cover plate and may be disassembled in

bearing into camshaft end plate.

similar

manner.

2. Position a new camshaft end plate oil seal (D) in end

plate.

1. Cut locking wire and remove four cap screws (A) and

3. Position a new preformed packing (C) in tachometer

flat washers.

drive adapter (B).

2. Separate and remove tachometer drive adapter (B)

4. Position tachometer drive adapter (B) on camshaft end

from camshaft end plate.

plate.

3. Remove and discard preformed packing (C).

5. Install four cap screws (A) and flat washers and install

4. Remove, and discard camshaft end plate oil seal (D).

locking wire securing screws.

Figure 6-213. Disassembling or assembling right camshaft cover plate.

b. Cleaning. Refer to paragraph 6-2.

c. Inspection and Repair. Refer

paragraphs

when replacing studs.

6-3 and 6-4, and (1) through (3), below.

(3) Inspect and repair camshaft as follows

(1) Inspect bushing-type bearing in cam-

and as shown in figure 6-214.

shaft end plate to limits specified in overhaul

6-178