 |
|||
|
|
|||
|
Page Title:
Figure 6-199a. Test stand assembly-FSN-4910-986-9873 |
|
||
| ||||||||||
|
|
 Figure
6-199a.
Test
stand
assembly-FSN-4910-986-9873.
advance assembly is mounted in bearing sup-
(4) Testing fuel injection pump advance
ports which simulate the mounting on the
assembly using test stand - 4910-986-9873.
Testing of fuel injection pump advance assembly
engine, and is loaded by using a basic AVDS-
is required on all units that have been overhauled
1790 series engine fuel injection pump which is
to
insure
optimum
engine
performance.
This
coupled to a drive gear. The test stand is in-
strumented to permit direct observation of the
testing will be accomplished prior to assembly of
the engine rear fan and accessory drive housing
advance assembly operating characteristics and
assembly. The test stand is designed to check
adjustments m a y b e m a d e
to the advance
assembly without removing
it from the test
and bench test the advance characteristics of the
stand. Procedures for bench testing the advance
fuel injection pump advance assembly, under
assembly are as follows and covered in figures 6-
conditions simulating engine operation over an
operating
range
of
200
to
2600
RPM.
The
199a
through
6-201:
6-165
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals