Figure 6-87. Pressing ball bearing into drive cluster gear

f. Assembly. Refer to figures 6-87 through 6-

6 7 . Torque tighten the drive shaft lock nut (fig.

6-72) and driven gear nut (fig. 6-70) as specified.

N o t e . The drive shaft (B, fig. 6-84) must be

pressed into the bearings from the large gear end

of the cluster gear.

1. Position ball bearing (A) in bore of drive cluster gear.

2. Press bearing into gear until bearing is seated against

the gear.

Note. Turn gear over and install thrust washer

( B , fig. 6-85). Aline thrust washer with installed

bearing and press second bearing in gear, as

outlined above, until seated against thrust

washer.

Figure 6-87. Pressing ball bearing into drive

cluster gear.

6-88