Table 6-6. Generator Adapter Standard and Oversize Stud Identification

Table 6-6. Generator Adapter Standard and Oversize Stud Identification

Note. Refer to figure 6-1 for oversize stud

identification.

Assembly.

Assemble generator drive

gearshaft and adapter following instructions

which accompany figures 6-26 and 6-27.

1. If ball bearings were removed from generator drive

gearshift, coat ball bearing (A) with engine oil, Military

Specification MIL-L-45199, and position bearing on

flange of gearshaft. Press bearing on gearshaft.

2 . Coat ball bearing (B) with engine oil, Military

Specification MIL-L-45199, and press the bearing on

the other end of the gearshaft in the same manner.

Figure 6-26. Pressing ball bearings on

generator drive gearshaft.

6-30