Figure 5-172. Removing or installing tie rods and attaching parts-left side view

Remove

Install

1. Remove cotter pin, slotted nut (A), and plate washer

1. Position 12 tie rods through crankcase and install six

and remove upper tie rod at No. 7 main bearing, from

plate washers, 12 slotted nuts (C), and cotter pins.

left side of crankcase assembly.

2. Position lower No. 7 main bearing tie rod (B) through

2. Remove lower No. 7 main bearing tie rod (B) slotted

crankcase from opposite (right) side of crankcase and

nut and plate washer from opposite (right) side of

install plate washer, slotted nut, and cotter pin.

crankcase and remove tie rod.

3. Position upper tie rod at No. 7 main bearing through

3. Remove 12 cotter pins, tie rod slotted nuts (C), and

crankcase and install plate washer, slotted nut (A) and

six plate washers from crankcase. Separate parts.

cotter pins.

Figure 5-172. Removing or installing tie rods and attaching

parts-left side view.

5-99