Oil Pan, Crankshaft Damper and Oil Filter Housing, Cylinder Air Deflectors, Cylinder Assemblies, and Pistons and Pins

Figure 5-134. Location of preformed

packings at oil transfer tubes in crankcase

a s s e m b l y - rear fan and accessory drive

housing mounting base.

Remove

1. Remove ten cotter pins, slotted nuts (A), and flat

washers.

2. Remove six cap screws (B) and flat washers.

3. Remove rear fan and accessory drive housing

mounting base (C) from crankcase assembly.

4. Remove and discard four preformed packings (D)

5-12. Oil Pan, Crankshaft Damper and Oil

from oil transfer counterbores in mounting base (or

from oil transfer tubes in rear fan and accessory drive

F i l t e r Housing, Cylinder Air Deflectors,

housing).

C y l i n d e r Assemblies, and Pistons and

Install

Pins

1. Position mounting base (C) on crankcase assembly.

2. Install six cap screws (B) and flat washers.

Refer

Table

5-9

for

illustrations

and

pins, slotted nuts (A), and flat

3. Install ten

d i s a s s e m b l y instructions.

Figure

references

are

washers.

listed in the table.

4. Install four new preformed packings (D) in oil

Note. For instructional purposes the removal

transfer counterbores in rear fan and accessory drive

housing mounting base (C).

o f one right bank cylinder assembly, piston, and

p i n is described. Remove balance of cylinders in

Figure 5-133. Removing or installing rear fan

a similar manner.

and accessory drive housing mounting base.

Table 5-9. Oil Pan, Crankshaft Damper and Oil Filter Housing,

Cylinder Air Deflectors, Cylinder Assemblies,

and Pistons and Pins

Component

Figure Reference

Oil Pan

5-135 through 5-137

Crankshaft Damper and Oil Filter Housing

5-138 through 5-140

Cylinder Air Deflectors, Cylinder Assemblies, Pistons and

5-141 through 5-147

Pins

5-74