Figure 5-123. Removing or installing front fan drive housing attaching parts.

Install

Remove

1. Install two drilled head cap screws (A) and flat

1. Cut locking wire and remove two drilled head cap

washers and install locking wire securing front fan drive

screws (A) and flat washers attaching front fan drive

housing to mounting base.

2. Two self-locking nuts at studs (B) will be installed

2. Note that two self-locking nuts were removed from

when the double angle bracket is installed (fig. 5-84).

studs (B) when the double angle bracket was removed

Figure 5-123. Removing or installing front fan drive housing

attaching parts.

5-69