Figure 5-93. Separating fuel injection pump splined coupler sleeves.

Figure 5-95. Separating fuel injection pump

1. Separate coupler sleeves (A).

2. Remove and discard preformed packing (B) from

diaphragm coupler.

coupler sleeves.

Figure 5-93. Separating fuel injection pump

splined coupler sleeves.

1. Cut locking wire and remove three bolts (A) and

Note. The fuel injection pump diaphragm

recessed washers.

couplers are not matched and do not require any

2. Loosen bolt (B) until threads are free. Bolt cannot be

rem oved until fuel injection pump is removed from

special markings.

engine. Remove pump and remove bolt (B) and

1. Turn engine using splined wrench -5120-793-7895 as

recessed washer from pump.

shown in figure 5-91 until two fuel injection pump

coupler bolts (A) are accessible. Remove bolts and lock

Figure 5-96. Removing fuel injection pump.

washers.

2. Repeat procedure in step 1 and remove remaining two

bolts and lock washers.

Figure 5-94. Removing fuel injection pump

diaphragm coupler bolts.

5-57