Section X. SERVICE OPERATIONS

Note. Draw flywheel to crankshaft by in-

stalling three transmission drive shaftgear and

flywheel bolts and alternately tighten about one

turn at a time to draw flywheel into dowel pins

w i t h o u t binding. R e m o v e b o l t s a n d i n s t a l l

transmission drive gearshaft following the above

procedure until both flywheel and transmission

d r i v e gearshaft are properly alined on dowel

pins.

Figure 4-183. Installing flywheel, using bolts

to draw flywheel against crankshaft.

Section X. SERVICE OPERATIONS

4-21. General

of engine disassembly to perform. Refer to Table

4-9 for illustrations and instructions on service

This section covers service operations

o p e r a t i o n s covered in this section. Figure and

allocated to the Direct Support Maintenance

p a r a g r a p h references will be listed under ap-

Organization. Procedures outlined in this section

propriate headings in the table.

are for service operations requiring a minimum

4-93