Figure 4-55. Removing or installing fuel injection pump mounting bolts and breather tube bracket engines

inserted in injection pump before pump is seated

Remove

on mounting base. It cannot be installed with

1. Cut lockingwire and remove two screws (A) attaching

b r e a t h e r tube bracket to pump. Remove bracket.

pump in position.

Install the two screws in the pump (early pump only).

2 . Cut locking wire and remove two bolts (B) and

1. Tighten bolt (D).

washers.

2. Install long bolt (C) and washer.

3. Remove bolt (C) and washer.

3. Install two short bolts (B) and washers. Install locking

4. Loosen bolt (D) until threads are free. Bolt cannot be

wire on bolts (B and C) and on bolts (B and D).

removed until after fuel injection pump is removed from

4 . Remove two screws (A) from pump (early pump

engine.

o n l y ) . Position breather tube bracket on pump and

Install

install two screws (A). Install locking wire.

Note. Be sure lower right hand fuel injection

pump long mounting bolt (D) and washer are

4-55.

Removing

installing

fuel

injection

pump

mounting

bolts and breather tube bracket-engines with

breather

tube

routed

around

injection

pump.

4-29