 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
14. REMOVE BEARING (1).
a. Using arbor press and bearing instal-
ler, press out and discard bearing (1).
13. INSPECT ROLLER BEARING (1)
15. CHECK GEAR (2).
IN GEAR (2).
a. Using telescoping gage set and
a. Inspect bearing (1) for damage.
micrometer caliper set, measure
See TM 9-214.
inside diameter of gear (2). Replace
gear if measurement is greater
b. If bearing (1) is damaged, go to
than 1.001 inches (25.43 mm).
step 14 If not, go to step 16.
16. REMOVE AUXILIARY MAKEUP
P U M P (3).
a. Remove four screws (4) and
17. REMOVE AND DISCARD THREE
washers (5).
PREFORMED PACKINGS (6), (7),
AND (8).
b. Remove pump (3).
GO TO NEXT PAGE
4-485
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals