 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
17. CHECK RING GEAR (1).
a.
Using micrometer caliper set,
measure thickness of ring gear (1) in
three places. Replace ring gear if any
thickness is less than 0.190 inch
(4.83 mm) and go to step 18.
16. INSPECT RING GEAR (1).
b.
Using a flat surface and feeler gage,
a. Remove ring gear (1) and inspect
check ring gear (1) for warpage.
both sides for damage. See
Check inside and outside edges in
three places.
b. If ring gear (1) is damaged,
Replace ring gear (1) if warpage is
c.
replace it and go to step 18.
greater than 0.010 inch (0.25 mm).
If not, go to step 17.
19. REMOVE BRAKES ( 5 ) AND(6).
20. DISCONNECT HOSE ASSEMBLY ( 7).
a. Disconnect swivel nut ( 8 ) from
elbow ( 9 ) on brake, ( 6 ).
21. INSPECT MAIN HOUSING INSERTS. See
18. DISCONNECT HOSE ASSEMBLY ( 2).
a. Repair inserts if damaged. See task
a. Disconnect swivel nut ( 3 ) from hose to
REPAIR MAIN HOUSING INSERTS,
boss elbow ( 4 ) on second range single
disk brake ( 5).
N
GO TO
EXT
PAGE
4-435
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals