 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
NOTE
All brake adjuster screws do not use Iockwire.
CHECK SHOULDERED SHAFT (1).
9. REMOVE ROD END CLEVIS (4)
a. Using micrometer caliper set, meas-
AND BRAKE ADJUSTER (5).
ure diameter (2). Replace shaft (1)
a. Remove and discard Iockwire (6),
if measurement is less than
if used, from two screws (7).
0.7490 inch (19.025 mm).
b. Using 3/8-inch drive brace handle and
b. Using micrometer caliper set, meas-
1/4-inch socket wrench attachment,
ure diameter (3). Replace shaft (1)
remove two screws (7).
if measurement is less than
c. Remove clevis (4) with adjuster (5)
0.9990 inch (25.375 mm).
NOTE
Rod end connector (8) has left-hand threads.
10. DISASSEMBLE ROD END CLEVIS (4)
AND ADJUSTER (5).
a.
Remove and discard cotter pin (9).
b.
Remove pin (10) from clevis (4).
c.
Loosen hexagon nut (11) and remove
two rod end connectors (8) and (12)
from adjuster (5).
d.
Remove nut (11) from rod end
connector (12).
GO TO NEXT PAGE
Change 2
4-281
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals