 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
13. INSTALL TWO EYEBOLTS (1) IN
TWO THREADED HOLES (2).
14. A T T A C H AND SECURE LIFTING
DEVICE (3) TO TWO EYEBOLTS (1).
15. L O O S E N HOUSING ASSEMBLY (4).
a. Use pry slot (5) to loosen housing
assembly (4).
CAUTION
Cross shaft must slide free when removing
housing assembly. Failure to do so can
cause damage to equipment.
16. PARTIALLY RAISE HOUSING
ASSEMBLY (4) TO FREE COMPONENTS.
(H) Feed hose assembly (6) through
a.
hole (7), Repairer lift housing
assembly (4) evenly 1/4 inch at a
time. Do not allow cross shaft (8)
to stick in spur gear (9).
Inspect that spur gear cluster (10)
b.
is not stuck to housing assembly (4).
If spur gear cluster (10) is stuck
c.
to housing (4), remove it and place
in positive clutch (11).
GO TO NEXT PAGE
4-223
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals