 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
17. CHECK GEAR(S) (1).
a. Using telescoping gage set and
micrometer caliper set, measure inside
diameter (2).
b. Replace gear (1) if measurement is
greater than 0.688 inch (17.48 mm).
19. DELETED
CAUTION
20. REPAIRER AND HELPER TURN
HOUSING (7) OVER WHILE HOLDING
Cross shaft spur gear may be loose and may
fall out when spur gear is removed. Damage
GEAR (4).
to equipment can occur.
21. REMOVE GEAR (4).
18. REMOVE SPUR GEAR (3).
a. Using pry bar, pry off gear (4).
a. (H) Hold cross shaft spur gear (4) and
gear (3) in place.
22. REMOVE TWO PLUGS (8).
b. Using retaining-ring pliers, remove
a. Using 3/8-inch drive ratchet handle and
retaining ring (5) from groove (6).
3/16-inch socket wrench attachment,
remove two plugs (8).
Remove bearing end plate (5A).
c.
b. Remove and discard two preformed
Lift housing (7) from gear (3) with
d.
packings (9).
bearing inner race (3A).
GO TO NEXT PAGE
4-187
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals