 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
9. INSPECT FOUR BRAKE PADS (4).
8. CHECK GEAR (1).
a. Inspect four pads (4) for damage.
a. Using micrometer caliper set, measure
outside diameters (2) and (3).
b. If pads (4) are not damaged, go to
step 10. If pads are damaged, go to
b. Replace gear (1) if either measurement
is less than 2.9524 inches (74.991 mm),
step 11.
11. REPAIRER AND HELPER TURN
RIGHT-HAND INTERMEDIATE HOUSING
ASSEMBLY (5) OVER AND PLACE ON
TWO WOOD BLOCKS.
12. REMOVE FOUR PAD ASSEMBLIES (4).
10. CHECK FOUR PADS (4).
a. (H) Using 1-inch drive ratchet handle
a. Using depth gage, measure height of
and 1 3/4-inch socket, hold pad
each pad (4).
assemblies (4). Repairer, remove four
b. If any pad (4) measures less than
screws (6) and washers (7).
0.644 inch (16.36 mm), go to step 11. If
b. Remove four pad assemblies (4) from
all four pads (4) measure 0.644
underside of housing (5). Discard four
inch (16.36 mm) or more, perform
pad assemblies.
step 11 and then go to step 13.
GO TO NEXT PAGE
4-185
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals