 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
4. CHECK CLUTCH DISK (1).
Using micrometer caliper set, measure
a.
thickness of disk (1) in three places.
Replace disk (1) if thickness is less than
b.
0.150 inch (3.81 mm).
c.
Using flat surface and feeler gage,
check disk (1) for warpage. Check
inside and outside edges in three
5. REMOVE GEAR (2).
places.
a. Using pry bar, pry out gear (2).
d.
Replace disk (1) if warpage is greater
b. (Deleted)
than 0.010 inch (0.25 mm).
NOTE
Ball bearings might not come out with gear.
One bearing may stay in Intermediate housing.
The other bearing may stay in single disk
brake.
6. INSPECT TWO BALL BEARINGS (4).
7. REMOVE DAMAGED BEARING(S) (4).
Inspect bearings (4) on each end of
a.
gear (2) for damage. See TM 9-214.
a. Using mechanical puller kit, remove
damaged bearing(s) (4). Discard
If either bearing (4) is damaged, go to
b.
bearing(s).
step 7. If not, go to step 9.
4-184
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals