 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
50. PLACE HOUSING ASSEMBLY (2)
ON TWO WOOD BLOCKS (ITEM 6).
a. Put blocks under outside edge
of housing assembly (2).
48. INSTALL GEAR ASSEMBLY (1).
a. Place housing assembly (2) over gear
51. USING BEARING NUT WRENCH, DRAG
assembly (1).
W R E N C H , AND HINGED HANDLE,
TIGHTEN NUT (6).
49. INSTALL CONE AND ROLLERS (3),
a. (H) Hold housing assembly (2).
SMALL END FIRST. INSTALL
WASHER (4), NEW KEY WASHER (5),
b. Tighten nut (6) a little with bearing
AND NUT (6).
nut wrench.
52. USING 3/8-INCH DRIVE TORQUE
WRENCH WITH ADAPTER AND
D R A G WRENCH, CHECK
BEARING DRAG.
a. (H) Hold housing assembly (2).
b. Turn torque wrench slowly one full
turn. If torque is 15-20 in-lb
(17-23 cmkg), go to step 53.
c. If torque is less than 15 in-lb
(17 cmkg), go to step 51. If torque
is more than 20 in-lb (23 cmkg),
loosen nut (6), then go to step 51.
GO TO NEXT PAGE
Change 1
4-135
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals