 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
NOTE
If either cone or rollers is damaged, both
must be discarded.
14. INSPECT GEAR (1).
16. INSPECT CONE AND ROLLERS (2).
a . Inspect gear (1) for damage. See
a. Inspect cone and rollers (2) for
damage. See TM 9-214.
b. Discard gear (1) if damaged.
b. If cone and rollers (2) are damaged,
go to step 17. If not, go to step 22.
15. GO TO STEP 26.
18. CHECK BEVEL GEAR SHAFT (4).
17. REMOVE CONE AND ROLLERS (2).
a. Using micrometer caliper set,
measure outside diameter of shaft (4).
a.
Insert drift punch through holes (3) in
gear shaft (4) and evenly tap off cone
b. If measurement of shaft (4) is less
and rollers (2).
than 3.3765 inches (85.763 mm), go to
step 19. If not, go to step 22.
Discard cone and rollers (2).
b.
GO TO NEXT PAGE
4-129
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals