 |
|||
|
|
|||
|
Page Title:
CHECK TURNING TORQUE OF INPUT BEVEL ASSEMBLY |
|
||
| ||||||||||
|
|
 TM 9-2520-270-34
CAUTION
Do not vary speed while turning input
gearshaft. Faulty readings can be obtained
and damage to equipment can occur.
115. CHECK TURNING TORQUE OF INPUT
BEVEL ASSEMBLY (1).
116. REMOVE RETAINER (3) AND
a. Using 3/8-inch drive torque wrench
SHIM(S) (4).
with adapter and drag wrench, slowly
a. Working on right side of transmission,
and smoothly turn input gearshaft (2)
remove six bolts (5).
completely around and measure
t u r n i n g torque.
b. Using plastic-faced hammer, tap spur
gearshaft (6) from opposite side of
b. If turning torque is not 35-50 in-lb
transmission to loosen retainer (3).
(40-58 cmkg), go to step 116. If turning
torque is 35-50 in-lb (40-58 cmkg), go
c. Using pry bar behind shim(s) (4), care-
to step 124.
fully remove retainer (3) and shim(s).
NOTE
Thickness of each shim is marked on face of shim.
117, F I N D TOTAL THICKNESS OF ALL
SHIM(S) (4),
118. IF TURNING TORQUE WAS GREATER
THAN 50 in-lb (52 cmkg), GO TO
STEP 119. IF TURNING TORQUE WAS
119. REPLACE SHIM(S) (4) WITH SET THAT
LESS THAN 35 in-lb (40 cmkg),
IS 0.005 INCH (0.13 mm) THICKER.
GO TO STEP 120.
GO TO STEP 121.
4-118
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals