MEASURE THICKNESS OF MOUNTING FLANGE

TM 9-2520-270-34

55. MEASURE THICKNESS OF MOUNTING

FLANGE (1) AND WASHERS (2).

a. Place two washers (2) from step 17 on

spot face (3).

b. Using micrometer caliper set, meas-

ure thickness of flange (1) and two

56. OBTAIN DIMENSION B.

washers (2) together in four places.

a. Add four thicknesses.

c. Put temporary mark (4) on flange (1)

b. Divide result of step 56a by four.

at four spot faces (3).

c. Record result as dimension B.

d. Retain washers (2).

NOTE

Fixture cannot be placed straight into housing.

It must be tilted at an angle so that flange

end of fixture fits through slot in gear shaft

housing hole. Fixture is exact fitting and

can easily stick.

57. INSTALL BEVEL GEAR SHIMMING

FIXTURE (5) THROUGH LEFT SIDE

OF TRANSMISSION (6).

a. Seat fixture (5) in transmission (6).

GO TO NEXT PAGE

4-105