 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
30. INSTALL SPINDLE (4).
a. Aline mark (5) on spindle (4) with
29. INSTALL GEAR (1) AND TWO
mark (6) on main housing (3).
THRUST WASHERS (2).
b. Using plastic-faced hammer, tap
a. Aline thrust washer (2), gear (1),
spindle (4) through main housing (3),
and second thrust washer (2) with
two thrust washers (2), and
hole in main housing (3).
gear (1),
31. INSTALL NEW GROOVED PIN (7).
a. Drive in new pin (7) until end is 0.02
to 0.05 inch (0.5- 1.3 mm) below edge
of hole (8).
32. USING DRIVE PIN PUNCH (9)
(ITEM 25), STAKE HOLE (8).
4-50
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals