 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
CAUTION
Do not deform shaft or housing. Equipment
can be damaged.
3. REMOVE AND DISCARD SEAL (1).
a. Using hammer and drive punch, deform
seal (1) so that pliers can grip it.
b. Grasp seal (1) and pull from
seal well (2).
c. Discard seal (1).
4. CLEAN WASHERS, SEAL WELLS,
AND SHAFTS. See page 2-2.
5. INSPECT WASHERS, SEAL WELLS,
AND SHAFTS. See page 2-5.
ASSEMBLE
6. INSERT NEW SEAL (1).
a. Coat new seal (1) with transmission oil.
b. Place shaft-seal starter (3) over
shaft (4).
Slide seal (1) over shaft-seal starter (3)
c.
7. INSTALL NEW RETAINING RING (6).
with lip (5) facing down.
a. Install washer (7).
Tap seal (1) into seal well (2) until
d
b. Using retaining-ring pliers, install
seated flush. Remove shaft-seal
new retaining ring (6).
starter (3).
END OF TASK
3-45
Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals