Inspection and Repair - TM-9-2520-254-340070

5-9. Cleaning

Refer to paragraph 5-2 for cleaning recom-

mendations.

5-10. Inspection and Repair

Refer to paragraph 5-3 for general inspection and

repair r e c o m m e n d a t i o n s . Repair and overhaul

(rebuild) points of measurement for fits, clearances,

and wear limits are indicated by small letters in

for wear limits information.

5-11. Assembly

All items not covered in a through c below are

installed as outlined in paragraph 5-58, steps 31

through 38 (fig. 5-114 through 5-121). No

overhaul (rebuild) of such components is required

or recommended.

a. Lockup Clutch Assembly (fig. 5-53).

(1) If bushing (5) in converter pump cover hub

w a s removed, use replacer 5120-572-8656 and

handle 5120-316-9182 (fig. 5-57) to install new

bushing.

(2) Install seal retainer (6) on converter pump

cover (4) hub with larger diameter toward open end

of cover. Install oil seal ring (7).

5-55.-Flattening

lock

strip

tab.

(3) Install piston seal ring (10) in groove of

lockup clutch piston (8) outside diameter.

(4) Insert lockup clutch piston (fig. 5-58) into

converter pump cover with stamped balance marks

(if any) alined so that piston guide pins will enter

nearest holes in piston.