Position torque converter housing

TM 9-2520-249-34& P

32. Using puller kit (1) shield (6), and adapters (5).

31. Position torque converter housing (1) on its side as

remove pump drive gear (4) and bearing (3).

shown.

Remove diaphragm seal ring (2). Tap bearing (3)

out of drive gear (4).

CAUTION

Before moving housing, grasp the turbine

shaft refer to step 30, callout (1) above) to

prevent an downward movement housing.

An downward movement might damage the

pitot and / or vanes in the pitot oil collector.

Remove diaphragm (2) by inserting driver (3) through

the rear of the housing. Tap the driver sharply with a

hammer to unseat the diaphragm.

NOTE

Do not remove the diaphragm center oil seal

unless replacement is necessary.

33. Flatten corners of lockstrip (1). Using a 5 / 16 inch

wrench, remove two bolts 121 from the pitot tube.

The pitot tube will fall free within the collector ring.

Remove the lockstrip

6-10