Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS AND ASSEMBLIES

TM 9-2520-246-34

interruptions.

ICE, MIL-L-2104. Allow the seal to soak for 45 minutes

before installation.

(4) When preparing a new oil seal for assembly,

2-11. Lubrication. Refer to LO 9-2320-209-12/1 for

place it in a small container of lube oil (OE/HDO 10)

lubrication instructions.

Section IV. REMOVAL AND INSTALLATION OF

MAJOR COMPONENTS AND ASSEMBLIES

2-14. Transfer, Models T-136-21 and T-136-27.

2-12. General. This section provides procedures for

Refer to TM 9-2320-209-34 for multifuel engine

the removal and installation of the following major

powered vehicles or TM 9-2320-209-20 for gasoline

components and assemblies: transmission, transfer,

engine powered vehicles.

and power takeoff assemblies.

2-15. Power Takeoffs, Models WN-7-28, WND-

2-13. Transmissions, Models 3052 and 3053A.

7-28, and P-136-C. Refer to TM 9-2320-209-34 for

Refer to TM 9-2320-209-34 for multifuel engine

multifuel engine powered vehicles or TM 9-2320-209-

powered vehicles or TM 9-2320-209-20 for gasoline

20 for gasoline engine powered vehicles.

powered vehicles.

2-18