 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR SINGLE DISK PIVOT STEER BRAKE ASSEMBLY -- Continued
0030 00
ASSEMBLY
NOTE
If optional pivot steer brake was removed, do Steps 1 - 6.
1.
Lubricate new packing (1) with grease or petrolatum, and install on release unit nut (2).
2.
Install release unit nut (2) in brake housing (3) using remover and replacer tool (4).
NOTE
Turn remover and replacer tool in the counterclockwise direction.
3.
Deform one thread in release unit nut (2) securely in two places a minimum of 45 degrees from holes in unit.
4.
Lubricate new packing (5) with grease or petrolatum, and install packing on release unit piston (6).
5.
Place brake lining (7) on face of release unit piston (6). Using brake and clutch reliner, install piston in housing (3) until
piston is flush with outer edge of release unit nut (2).
6.
Lubricate new packing (1) with grease or petrolatum, and install packing on shoulder screw (2). Install screw in release
unit piston (3).
0030 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals