Remove two cap screws

TM 9-2520-238-34

REPAIR DIFFERENTIAL RIGHT ANGLE GEARBOX -- Continued

0028 00

24. Check preload by installing input yoke (part of carrier power train installation) with cap screw installed in yoke flange.

Apply torque to cap screw.

25. Reading on torque wrench (WP 0033 00, Item 39) should be 10-25 lb-in (2 Nm) rolling torque (take reading when the

yoke just starts to turn).

26. If reading is not obtained, remove retainer (4) and peeled shim (6) from bearing housing (1). Repeat Steps 18 - 25 above

with new shim until correct reading is obtained.

27. Remove two cap screws (3) and bearing housing (1) as an assembly from gearbox housing (2).

0028 00-14