Install sleeve bearing

TM 9-2520-238-34

REPAIR DIFFERENTIAL STEERING CONTROL ASSEMBLY -- Continued

0026 00

18. Install sleeve bearing (1) on control flange assembly (2) with grooves pointing to the right.

NOTE

Check that 10 cap screws being installed are grade 8 screws (six radial marks on screw heads).

If brake drum hub was removed from brake drum in page 0026 00-2 above, do Step 19.

NOTE

If sleeve bearing (3120-00-782-4191, 8756536) is installed on differential spider, inside diameter

of spider will be 2.249 to 2.251 inches (5.71 cm).

NOTE

If spider is equipped with sleeve bearing (3120-00-782-4191, 8756536), the fit of spider on gear

hub will be 0.0010L to 0.00040L.

19. Install brake drum hub (3) on brake drum (4). Secure with 10 cap screws (5), 20 washers (6), and 10 slotted nuts (7).

Tighten nuts to 420-480 lb-in (47-54 Nm) torque. Use torque wrench (WP 0033 00, Item 41). Install 10 new cotter

pins (8).

20. Install brake drum hub (3) with attached brake drum (4) on control flange assembly (2).

21. Install bearing thrust washer (9) on drive shaft of control flange assembly (2).

0026 00-11