Straighten tabs on eight key washers

TM 9-2520-238-34

REPAIR FINAL DRIVE ASSEMBLIES A AND B -- Continued

0020 00

11. Straighten tabs on eight key washers (1). Remove eight cap screws (2), key washers (1), bearing and oil seal retainer (3)

with output shaft assembly (4) and attached parts, and gasket (5) from housing (6). Discard key washers and gasket.

12. Remove retaining ring (7) from housing (6).

13. Straighten tabs on key washer (8). Remove round nut (9), key washer (8) and bearing washer (10) from shaft assembly

(4). Discard key washer.

14. Remove parts from shaft assembly (4). Position three straight pins on remover and replacer with pins in unthreaded

holes in flange of shaft assembly. Use an arbor press to press roller bearing (11), retainer (3) with encased oil seal (12),

and seal spacer (13) from shaft assembly. Remove oil seal from retainer. Discard seal.

0020 00-5