DISASSEMBLY-continued - TM-9-2520-238-340148

TM 9-2520-238-34

REPLACE TRANSFER GEARCASE A, B, OR C WITH SERVICE SPARE TRANSFER

0018 00

GEARCASE E -- Continued

CAUTION

Laminated shim and input bearing retainer are matched for bearing preload at initial assembly.

Retain shim and retainer with same gearcase. When replacing gearcase C, replace pulley

instead of retainer. Failure to comply may cause bearing failure.

NOTE

Steps 16 - 18 apply to unserviceable transfer gearcase C.

16. Straighten tabs on four key washers (1). Remove four cap screws (2), key washers, bearing retainer (3), packing (4), and

laminated shim (5) from housing cover (6). Retain retainer and laminated shim with gearcase. Discard key washers and

packing.

17. Remove retaining ring (7) and three-grooved pulley (8) from retainer (3). Discard retaining ring.

18. Remove encased oil seal (9) from retainer (3). Discard oil seal.

0018 00-6