Assemble helical gearshaft cluster

TM 9-2520-238-34

REPAIR TRANSFER GEARCASES A, B, AND C -- Continued

0017 00

NOTE

Check that mating surfaces of second intermediate gear and primary pump-drive gear are

clean. Alignment of gear teeth is not necessary.

Assemble helical gearshaft cluster (1). If dowel holes exist in second intermediate gear (2) and primary pump-drive gear

(3), align holes in each gear. Secure gears together with new spring pin (4). Stake pin three equal places at both ends. If

dowel holes do not exist in either gears (2) or (3), assemble gears and drill a 0.375 to 0.380 inch diameter hole using a 3/

8 inch drill. Secure gear (2) and gear (3) together with new spring pin (4). Stake pin three equal places at both ends.

If removed, install bearing cone (5) and bearing cone (6) on helical gearshaft cluster (1). Install cluster in housing (7)

meshing teeth of second intermediate gear (2) with first intermediate gear (8).

If removed, install bearing cone (9) and bearing cone (10) on output gear (11). Install gear in housing (7) meshing teeth

with second intermediate gear (2).

0017 00-15