 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR COOLING FAN RIGHT ANGLE DRIVES A AND B -- Continued
0015 00
NOTE
Ball bearings are a matched set and both must be replaced if either is defective.
4.
Disassemble spindle assembly (1) as follows:
a.
If inspection indicates needle bearing (2) must be replaced, remove retaining ring (3) and needle bearing from
shouldered shaft (4). Discard needle bearing.
b.
Press shouldered shaft (4) and bevel gear (5) from ball bearings (6) in bearing housing (7). Use arbor press.
c.
Remove two ball bearings (6) from bearing housing (7).
d.
Separate bevel gear (5) from shouldered shaft (4). Use arbor press.
e.
Remove machine key (8) from shouldered shaft (4).
f.
If inspection indicates that orifice spring pin (9) is plugged, clean spring pin. If spring pin is damaged, remove pin
from shouldered shaft (4). Discard pin.
0015 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals