Counterbalance Cable Removal. - TM-55-4920-439-13-P0017

TM 55-4920-439-13&P

Counterbalance Cable Removal.

1. After shop erection is complete (AND

COUNTERBALANCE CABLES ARE SECURED),

remove three screws (1) from cable retainer block (2).

2. Let cable (3) and retainer block (2) hang

loose next to shelter (4).

Reinstall retainer block screws (1) and

secure.

e. Shop is now ready for reconfiguration of

equipment to operational mode.

NOTE

All equipment or tools secured to the

floor or walls of the shelter must be

carefully tightened to specific torque

limits. See Appendix F.

SECTION II. PREPARING SHOP FOR OPERATION

2-2. ECU Shelves, lowering procedures.

NOTE

(For shelter P/N 136-0000-101) One

ECU opening is located in the fold-

out end wall and one ECU opening is

located in the fold-out side wall. (For

shelter P/N 5-4-2828-1) Both ECU

openings are located in the fold-out

end walls. One ECU opening in each

fold-out end wall.

Remove four plugs (1) on outside of each shelf

(2).

Change 1 2-3