3-154 MAGNETO - INSPECT - Continued
Remove access panel.
Inspect for weak magneto ignition spark.
Remove ignition lead from spark plug.
Lay the ignition lead terminal down close enough
to the cylinder head shroud to observe a spark.
With engine starter, turn engine over and watch
for spark discharge which should occur.
Install ignition lead on spark plug and tighten.
Repeat the check for each spark plug.
If there is a weak spark or none at all, check
breaker point opening. If weak or no spark condition
exists after checking breaker points, replace
magneto, para 3-156.
Install access panel.
END OF TASK
This task covers:
63B Wheel Vehicle
Kit, NSN 5180-00-545-8645
GO TO NEXT PAGE