REMOTE VALVE CONTROL.

TM 55-1930-208-24

4-17. CLUTCH REPAIR-Continued.

c. Reassembly-Continued.

(f) Install key (12) in the keyway of the clutch drive shaft. Attach a chain wrench to the drive shaft to

prevent the drive shaft from turning.

(g) Tighten the clutch drive shaft nut (6) to 225-23 lb-ft (307-314 Nm).

(h) Thread the small end of the flexible grease tube (4) in the hole in the side of the clutch release

sleeve collar. Insert the opposite end of the tube through the hole in the side of the clutch housing

and install the tube retaining nut (5). Tighten the retaining nut while holding the tube nut inside the

clutch housing from turning. Install the grease fitting (49) in the tube.

(i) Attach the inspection hole cover (2) and gaskets (3) to the clutch housing with screws (1).

4-18. REMOTE VALVE CONTROL.

This task covers:

a. Removal

b. Repair

c. Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanics (Item 1, Appendix B)

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

a. Removal. (Refer to figure 4-63).

(1) Remove nut (1) and handwheel (2).

(2) Remove two nuts (3), two bolts (4), reach rod (5), pipe (6), and coupling (7).

(3) Remove two nuts (8), two bolts (9), reach rod (10), and coupling (11).

(4) Remove nut (12), bolt (13), and swivel (14).

(5) Remove four nuts (15), four lockwashers (16), two U-bolts (17), and coupling (18).

b. Repair. Repair is limited to replacing defective parts.

4-88