Disassembly. - TM-55-1930-208-240162

TM 55-1930-208-24

b. Disassembly.

(1) Refer to figure 3-70 and remove pin (9), lever (10) and two brackets (11).

(2) Loosen eight adjusting screws (12) and remove four control levers (13) and spring (14).

(3) Remove screw (15), lockwasher (16), and rocker arm (17).

c. Cleaning.

(1) Clean all parts in fuel oil.

(2) Wipe off excess oil and allow to dry.

d. Inspection.

(1) Inspect all parts for cracks, wear, bends, rust, or corrosion.

(2) Inspect spring for loss of resilience.

e. Repair. Repair is limited to the replacement of defective parts.

f. Reassembly.

(1) Refer to figure 3-70 and install rocker arm (17) on shaft and lever assembly (8) and secure with lockwasher

(16) and screw (15).

(2) Install four levers (13) and tighten eight adjusting screws (12).

(3) Install spring (14) and two brackets (11) on shaft and lever assembly.

(4) Install lever (10) and pin (9).

g. Installation.

(1) Refer to figure 3-70 and position shaft and lever assembly into position. Be sure all levers fit into injector

racks.

(2) Install four lockwashers (7) and four screws (6). Torque the screws (6) to 10-12 lb-ft (14-16 Nm).

(3) Position fuel control rod into lever (10) and secure with pin (5) and cotter pin (4).

(4) Install plate (3), nut (1), and bolt (2). Tighten nut (1).

3-125