Click here to make tpub.com your Home Page

Page Title: Assembly
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 55-1930-208-24
3-19.
BLOWER - Continued.
f. Assembly - Continued.
(10) Push rotor shafts and oil pilots on through oil seals.
(11) Remove oil seal pilots J6270-5 (1, figure 3-36).
(12) Refer to figure 3-37 and place an oil seal pilot (1) on end of rotor shaft.
(13) Place rear plate (2) in position after lightly coating housing mating surface with sealing compound
(item 22, Appendix C).
(14) Place rear plate (2) over pilot (1) and gently tap the plate with a soft mallet to drive the plate over
the dowel pins.
(15) Install two screws (3) and torque them to 5-10 lb-ft (7-14 Nm).
(16) Remove both pilots (1).
Figure 3-37. Rear End Plate, Installation.
(17) Refer to figure 3-38 and lubricate bearings with engine oil (item 8, Appendix C).
(18) Place bearing (1) numbered side out, into position in the front end plate. Use a bearing driver
J6270-4 and tap the bearing onto the shaft and into the plate.
(19) Repeat steps (17) and (18) for the other bearing.
(20) Install two bearing retainers (2) and secure with six washers (3) and six bolts (4). Torque bolts to
7-9 lb-ft (9-12 Nm).
(21) Start the end of water pump coupling (5) straight into the left hand rotor shaft.
(22) Place clean, soft cloths (item 23, Appendix C) between the rotors and the rotor and housing to
prevent them from turning.
3-66

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business