Reassembly - Continued. - TM-55-1930-208-240068

TM 55-1930-208-24

(z) Start the speed adjusting lever roll (spring) pin (5) straight into the pin hole in the lever; then tap the pin

through the lever and shaft until it is flush with the top of the lever.

(aa) Apply a thin coat of sealant (item 21, Appendix C) to the outside diameter of the speed adjusting lever

shaft cup plug (40). Insert the plug, with gasket (41), straight into the boss in the opposite side of governor

housing.

(ab) Apply a thin coat of sealant (item 21, Appendix C) to the outside diameter of the speed adjusting shaft oil

seal (42). Place the oil seal, lip of seal facing in, over the end of the speed adjusting shaft and start it in

the bore in the housing, then press the seal in flush with the edge of the boss.

(ac) Place the flat side of the speed droop adjusting bracket (11) against the top (bolting) surface of the

terminal lever, with the pin in the bracket in the slot of the speed adjusting floating lever. Secure the

bracket to the lever with a flat washer (10), lockwasher (9), and screw (8).

(ad) Thread lock nut (2) on the maximum speed adjusting screw (3). Place the washer (4) on the adjusting

screw, then thread the screw approximately half way in the governor housing.

(ae) Affix a new gasket (1) to the governor housing.

(3) Refer to figure 3-19 and reassemble the governor sub-cap.

(a) Press a new fuel rod bushing (14) in the sub-cap flush with the bottom of the counter-bore. Then, press a

new fuel rod oil seal (12), with the lip of the seal facing out, straight in and against the bottom of the

counter-bore in the sub-cap (15).

(b) Apply a thin coat of sealant (item 21, Appendix C) to outside diameter of a new governor sub-cap cup plug

(13). Start the plug, open end out, straight into the plug opening; then press the plug in against the

shoulder in the bore of the sub-cap.

cap.

(d) Place the large end of the fuel rod spring (8) over the threaded end of the fuel rod and push it in against

the cup plug in the sub-cap.

(e) Place the fuel rod disc (7), large outside diameter end first, over the threaded end of the fuel rod and

against the fuel rod spring.

(f) Place the shut down spring (6) over the end of the fuel rod and over the end of the fuel rod disc.

(g) Place the fuel rod collar (5), small outside diameter end first, over the end of the fuel rod and inside the

shut down spring.

3-51