GOVERNOR.

TM 55-1930-208-24

3-17. GOVERNOR.

This task covers:

a. Removal

b. Disassembly

Cleaning

d. Inspection

e. Repair

f. Reassembly

g. Installation

h. Adjustment

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Wrench, Torque (Item 71, Appendix B)

Materials Required:

Compound, Sealing (International Compound No. 2, Item 13, Appendix C)

Gasket P/N 3224773

Gasket P/N 3249110

Gasket P/N 5150246

Gasket P/N 5169866

Gasket P/N 5197066

Oil, Lubricating (Item 12, Appendix C)

Pin, Cotter P/N 103373

Seal P/N 249112

Seal P/N 3307753

Seal P/N 5197065

Solvent, Cleaning (Item 4, Appendix C)

Washer, Lock P/N MS35333-39

Washer, Lock P/N MS35338-44

Washer, Lock P/N MS35338-45

Washer, Lock P/N 120217

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

Valve rocker cover removed (paragraph 3-36).

Fuel rod disconnected from fuel injector control tube (paragraph 3-39).

Throttle control lever disconnected (paragraph 3-16).

a. Removal. (Refer to figure 3-17).

(1) Disconnect the oil inlet tube assembly (1) from the governor oil inlet plug.

(2) Remove five cover screws (2), then lift the governor cover (3) and gasket (4) from the governor housing.

Remove the two sub-caps to cylinder head bolts (5).

(3) Refer to figure 3-18 and remove the two sub-cap retaining screws and lockwashers.

3-40