 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-1915-200-10
b. Operating Procedures.
(1) Place grinder ON/OFF switch (4) to ON
position.
WARNING
Wear eye protection when
(2) Allow grinder to reach full speed before
starting to grind.
using this equipment.
Use
grinding
wheel
(3) Use tool rests (3) for best grinding results.
prescribed for grinding speed.
(4) Hold the piece being ground firmly against
Do not connect the bench
the wheel (2) with a light but steady pressure.
grinder to a power source,
(5) Keep tool rests (3) adjusted to within 1/16
receptacle, or power outlet
inch of grinding wheel (2).
with voltage greater than
(6) When grinding is complete, place
specified. Serious personal
ON/OFF switch (4) in the OFF position.
injury or damage to the
2-5.22. Belt Drive Lathe.
equipment can occur. If in
2-5.22.1. Preparation for Use.
doubt, do not plug in the
WARNING
bench grinder.
Using a
Shock hazard exists with this
power source with voltage
equipment.
Ensure that
less than the nameplate
plugs, connections, and wire
rating may cause damage to
are
in
proper
working
equipment.
condition.
Never leave
Do not modify the plug.
equipment running when
Shock hazard and personal
unattended. Disconnect from
injury
or
damage
to
power source when servicing
equipment may occur.
or changing bits, blades,
Repair or replace damaged or
cutters or other accessories.
worn cord immediately.
Do not operate equipment in
Wear proper clothing. Loose
wet or damp environment.
clothing, jewelry, gloves, or
Use eye protection.
Keep
neckties may become caught
guards in place. Do not wear
in grinder.
loose clothing or articles of
Do not overreach.
Keep
jewelry. Do not overreach;
proper footing at all times while
keep proper footing.
using grinder.
CAUTION
DO
NOT
leave
grinder
Do not force tools, keep work
running when not in use.
secured in clamps or vises. Do not
CAUTION
overload machinery. Do not change
Excessive or sudden pressure slows
any piece of equipment accessory or
the grinding action, overloads the
component while lathe is running.
motor, puts dangerous stresses on
a. Position the HIGH-LOW speed change lever (4,
the wheel, gouges the wheel, and
causes rough grinding with reduced
b. Manually rotate the spindle to ensure free
accuracy.
movement.
2-481
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals